Roller section steel pass-through shot blasting machine is a special shot blasting cleaning equipment for cleaning steel , plates, structural parts, pipe and bars. It can apply strong shot blasting to the original steel surface to remove the rust layer ,welding slag and oxide scale on it , so that it can obtain a uniform metallic luster. In order to improve the coating quality and anti-corrosion effect of steel. This machine is horizontal roller type shot blasting equipment. It consists of a shot blasting cleaning room, a shot blaster assembly , a shot material circulation purification system , a workpiece conveying system , a abrasive recovery system, a secondary dust removal system ,PLC electrical control , and frequency conversion. HS69 series shot blasting machine cleaning steel specifications. Width :0.-3meters, height 0.2-3meters, length 2-30meters. The whole equipment including shot blasting chamber ,  abrasive control unit, shot blasting system, abrasive recycling sorting storage system. Ventilation and dust removal system, roller conveyor, electrical control system, maintenance plateform, safety system,etc. mechanical and electrical systems should be equipped with reliable safety protection devices. The shot blasting equipment conforms to the relevant standards, certifications and requirements of EU CE, German TUV, and French BV.
Roller profile steel pass-through shot blasting machine
Front and rear sealed room: together with the cleaning room, a wide workpiece cleaning space is formed. The hot zone of the shot blast sealed room is protected by high wear-resistant rubber sheet. All guards can be replaced easily. The front and rear seal chambers are designed with multiple layers of interleaved wear-resistant rubber sheet seals. The device is tightly sealed, a certain negative pressure is formed in the chamber and no dust escapes.
Shot blasting chamber
This device is composed of front and rear auxiliary rooms , shot blasting room, conveyor system, abrasive circulation device, maintenance platform, dust removal system and electric control system.  Abrasive principle : the chamber body and shot blasting device are designed by 3D and dynamic simulation, the shot blaster is at an appropriate angle to the direction of travel of the steel. In order to produce a better impact effect, and prevent the abrasive empty throwing , affecting the cleaning effect,  maximize equipment performance.